Glass Fiber Reinforced Pipe GRP Winding Production Line CNC Computer Control

Best sales Industrial Control Computer Glass Fiber Reinforced Winding Machine

. Introduction

This machine is used wingding Glass Fiber Reinforced Plastics on the tube. It features hige precision,high-productivity,low energy consumption and simple installation & controlling,easy to operate.the machine high popularity among the FRP industry.

This machien include three parts:

       1.Main axle system.

The main axle is a constant torque motor, which is controlled by a frequency converter.

      2.Winding cart.

The Winding cart uses AC servo motor to control the speed of its walking back and forth.

      3.Control system

Adopts industrial control computer, through the parameters set, complete the whole process of automatic control.

Specification: power 3.0KW voltage 380V
Winding diameter 60-1220
The width of the width of 250-300
1, reference installation sketch map, in order to work the length of the pipe to the correct installation of equipment. Fixed front, rear support roller frame, power supply.
2, parallel to the pipe axis with 2 30*30 angle dip laying vehicle guide, proper placement of car
3, according to the length of the steel pipe to adjust the distance between the roller, the replacement of the transmission chain.
4, the lifting of the steel pipe, both ends of the roller, the size of the smuggling of steel pipe to adjust the speed of rotation.
5, will be glass fiber cloth wear in glass cloth roller retaining plate positioning in the middle position, the cloth pressing shaft, loosen the scraping plate for cloth end from scraping plate and a cloth between the shaft through and pressure presser shaft and positioned.
6, the deployment of a resin poured into the material groove material tank volume 15 liters) to start the machine and the cloth winding on the end part of the steel pipe, then push the car to drive the Bufu width uniform.
7, adjust the scraper position control with resin content of glass fiber.
8, when the device is switched on the motor and then slowly rotating the controller knob, skilled after the time when the machine is fixed, can not move the adjusting button, and the first motor, and then switch on the controller power supply.
9, when the motor stops, first cut off the power supply, and then cut off the drive motor power.

.Taken the after-sales service and technical support

    1. provide free technical guidance equipment installation and debugging.

    2. equipment warranty for 12 months.

Packaging & Shipping